.

Remove the handle and spindle, and then you should be able to pull the mortise lock out from the side.

Drilling will be a. .

These door knobs come with a small push.

Focusing on Door Exploits.

Step 1 - Remove the. Use a screwdriver to unscrew all of the visible screws on the doorknob. Depending on the door type, there are two ways of unlocking a door using a screwdriver.

After unscrewing, wiggle the.

To remove a locked door knob without a key, hold and twist the knob, then turn it in the opening direction. This was a keyed door lever lock but I mention how to do the same with the standard. Remove DoorKnobs with Screws.

The blades must be narrow enough to fit completely inside the lock. .

The.

Best of all, it only requires a hammer and a small screwdriver! Watch the video above for a full step-by-step.

. Step 2: Insert 1/8 bit into the drill and drill slowly.

. This is how to remove a door knob / lock / handle with no visible screws and a stuck latch spindle.

Latch: The part of the lock that goes into the striker plate.
Use a.
2 Pull the lock out of the door 4.

You will need to know this in order to remove this door lock.

This will release the handle and may expose screws underneath.

The job will be much easier if you have visible screws on your doorknob. . .

Removing a Knob Door Lock (With. Some doors require locating the mounting screws and removing them to. Remove the doorknob and faceplate from your side of the door. Step 2: Remove the knob. These door knobs come with a small push.

Table of Contents [ hide] How to Remove a Keyed Deadbolt Lock From the Outside Using a Drill.

Next, take off the handle and glue the knob in place so that it cannot be operated. Locate the small pin-hole on the shaft.

Remove the handle and spindle, and then you should be able to pull the mortise lock out from the side.

Repeat this procedure for the reverse side of the door.

Table of Contents [ hide] How to Remove a Keyed Deadbolt Lock From the Outside Using a Drill.

2 Pull the lock out of the door.

The blades must be narrow enough to fit completely inside the lock.